-
How do I pull codes on my 2015 Etec 250 HO? Overheat alarm
My 2015 Etec 250 HO gave me a overheat alarm twice this past weekend, when running 40mph with abt 22psi water pressure at 4200rpm. Raised motor to check if nose cone pick up was clogged, was not. Restarted and continued to run, came on again. Lowered speeds/rpm to 3000 (20psi water) & got back to dock without further issue.
Short shaft motor sits on cat style hull. Have had this issue a few years back, had the springs changed out (water pressure inlet spring?) to a lower pressure spring IIRC and problem went away.
What cable/software do I need to pull codes on this motor and figure out where to start?
Model # E250HGLABF
Thanks in advance!
-
You will find several providers starting at this site https://www.etecownersgroup.com/categories.
the easiest is to make the purchase through your dealer.