Does anybody have experience attaching the rear tie down straps to their jackplate instead of the eyelets?
Does anybody have experience attaching the rear tie down straps to their jackplate instead of the eyelets?
1993 Bullet 20XD
2000 Mercury ProMax 225
I do not have experience doing this but see no reason not to.
2020 Triton 18 TRX
Tournament Fishing Package
2020 Mercury 200 Pro XS V8 Serial # 2B588923
Minn Kota Ultrex 80# I Pilot Link
Hi Jacker EZ 6" Jack Plate
Bravo 1 FS 24 Pitch Prop
Humminbird Helix 7 SI GPS CHIRP G2 Bow
Humminbird Helix 7 CHIRP MEGA GPS DI G3 Console
Trick Step Boarding Steps
RMP Engine Support
Right on
1993 Bullet 20XD
2000 Mercury ProMax 225
I’m pretty sure the gamblers come like that from the factory.
Not experienced in this area, but if I had a Hydraulic plate, I would not hook to the motor side.
My opinion, wish Bullets were made without the rear tie eyes and just have a couple holes in the jack plate to hook to.
Cool, thanks y’all
1993 Bullet 20XD
2000 Mercury ProMax 225
I would just use what is built into the boat they are already there and do the job.
Agreed, but I’m thinking about having them deleted when I have the transom replaced.
1993 Bullet 20XD
2000 Mercury ProMax 225