I can’t get the side panel to turn on. I know others have bumped into the same issue. I look under the helm for the P.A.D.S fuse, but I can’t seem to locate it. Would someone be kind enough to post a picture of it?
I can’t get the side panel to turn on. I know others have bumped into the same issue. I look under the helm for the P.A.D.S fuse, but I can’t seem to locate it. Would someone be kind enough to post a picture of it?
This should help… circled in blue near the clean power block.
6EE8235B-6203-4A7E-AE26-12D7B2043BC1.jpeg
zoomed out
AE26BF30-3D6E-45A6-A98F-E07B785F223C.jpeg
May also look at the breaker behind the cranking battery.
It is probably not a breaker. Mine would sometimes light half, not at all and even occasionally work properly. Even without lighting up, all of the functions would usually work. Or not. The panel was replaced under warranty and has been working perfectly since.
My fuse holder says 'CAM' and not 'PADS'. Maybe they run out of PADS fuse holders during assembly. I checked the fuse and it is good.
Don't know that it might work but i have seen it lots of times fix some issues kind of like this by disconnecting the ground battery lead, letting it set for a couple minutes then hook it back up. This absolutely worked several times on brand X boats.
Upon closer inspection, I noticed a crack in the main 90 amp breaker housing. I gave it a quick trip test and it’s not working right. I just now went online to find a new one, but I can’t seem to locate the exact same flush mount breaker. Blue Seas Systems doesn’t seem to carry the exact model 185090P. Has anyone else had to replace their main breaker? Also, I discovered the main batteries negative nut had backed off to the point of not making contact with the cable it was securing down. I’m assuming that may have messed up the breaker.
Mine will randomly not turn on. Its just the fuse holder. I pull the cap off and push the fuse down all the way and its fine. I think its just not pinching the fuse tight enough and works loose