My Nissan has the black plastic step plate cover over rear bumper. The lock tab is broke off of the plastic step. Would like to glue it and clamp down till sets up. Any suggestions on type of glue.
My Nissan has the black plastic step plate cover over rear bumper. The lock tab is broke off of the plastic step. Would like to glue it and clamp down till sets up. Any suggestions on type of glue.
Help
Gorilla Glue
'05 Stratos 200 ProXL, '05 Evinrude 225HO
Or loctite.
Thanks ,never used gorilla glue too much of a gap for loctite
Non hard to find a modern glue that will stick.the sniffers like the good stuff, so it's hard to find.
Ive always used clear silicone for that type of application. Could also use 3m trim double sided tape. Its for auto trim panels and can be found at any auto parts store.
always had great luck with 3m weatherstrip adhesive
Putting a clown in the castle doesn't make him a king, it turns the castle into a circus
Contact cement, if you have a decent fit with lots of surface contact area. It might help to clamp/weigh the plastic to the bumper and apply some heat to improve the fit and contact area before you try to glue it. I also see a lot of folks liking "Shoo Gloo" or something like that. Haven't used that, myself.
Don't bother me, I'm screwing for virginity.
I killed a 12-pack just to watch it die.
I am doing some remodeling and needed something good and strong, I just used something new to me and have a new favorite glue.....try it
Its made by DAP, its called Rapid Fuse all purpose adhesive
Label says dries in 30 seconds and it does, says bonds virtually everything and so far everything I have tried it on it has bonded fast and strong, its like super glue being thin and clear but bonds fantastic, no I do not work for them.....lol.....I just tried this and have used it on several materials and its been great.......Look it up
another vote for 3m molding tape.......
5200
Ranger 619 * Honda 200* Minn Kota* Humminbird *Garmin
Fenwick *Abu Garcia
3M 5200
Bass Boat
Powered by an outboard
Electronics at helm and up front
Pulled by my truck
Or 4200
1988 Ranger 364V
150HP Merc Black Max
3m outdoor double side or trim tape.
2006 Stratos 294 Pro XL.2005 Yamaha 200 VMAX 3.1L. 8" Hydro Dynamics Rapid Jack. Ultrex 112 I-Plot link. 2 Helix 10 Chirp Mega SI GPS G2N.
If that step plate is polyethylene and i'm pretty sure it is,in reality,nothing really sticks to it for very long. The 3M molding tape wold be your best bet. If you have gaps to fill,3M windshield sealant.
Junkyard , new to you step plate. Not gluing anything to my vehicles.
XPRESS H 18 SS, YAMAHA 115
Double sided tape, as others have stated. If you've got a gap most glue is going to have a hard time.
What about euroflex. I use this in odd glue together and works great!
2013 Pantera 2
200 Pro XS (2b009069)
Ghost Trolling Motor