Remote Button Action Description (M)
- Move to Idle Diagnostics
- See bullet 4 above. Exits any mode below.
Right Button, >
- Show Center Calibration
- Shaft will rotate to the center position and if set correctly will align with the head. This value is not set with Rev F. software. If software was upgraded you will hear an error beep. This doesn’t mean there is an issue with the product. Just that it could need calibration sequence per the manual for a new main controller
Left Button, <
- Show Keel Calibration
- Shaft will rotate to keel position and if set correctly will align with the keel of the boat. If not, perform M112.
1
- Show Toe Down Hard Stop
- Shaft rotate to toe down hard stop. If it doesn’t look good, then perform M284/M285
2
- Show Heel Down Hard Stop
- Shaft will rotate to heel down hard stop. If it doesn’t look good, then perform M284/M285.
3
- Check Encoder
- Shaft rotates to heel down, evaluates the encoder as it moves to toe down. After evaluation it rotates back to heel down while displaying the status. Red means the Encoder needs to be replaced. Yellow means the encoder needs to be aligned properly. Green means the encoder is good.
4
- Display Wireless Receiver Comm Status
- Red for no communications – replace main controller.
Green status means wireless is okay.5
- Display Sensor Board Communications Status
- Red for no communications – replace sensor controller.
Green status means sensor is okay.6
- Display Pinpoint Communications Status
- Red for no communications – replace main controller.
Green status means pinpoint is okay.7
- Display Foot Pedal Communications Status
- Red for no comm – replace foot pedal controller.
Green status means foot pedal is okay.