-
Replacing spikes on 10’ Blades, spike stuck
I’m replacing the spikes on two power pole 10’ blades. Got one done, but the other spike is stuck in the blade. Any tips how to get it out??
-
BBC SPONSOR/ Shallow Water Anchors Moderator
lil wd 40 and wiggle pull should come right out. normally a wiggle and pull and your good but have seen some stuck pretty good. may even attract some fish to the boat when your done lol, ya know what they say about wd 40
-
Member
Had the same issue. Took the spike and knuckle out of the frame, put a little soapy water on where the spike goes into the knuckle and tapped it out with a dead blow hammer. Did the same putting the new spike in.