Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Jan 2010
    Location
    Virginia Beach
    Posts
    24

    Anyone Mount a Hummingbird 360 to a Minkota edge trolling motor

    As stated above I have an Edge trolling motor. I looked up the requirements/compatibility with trolling motors and the Edge was not listed. The only reason I can think that it wont work is due to the diameter of the shaft, and i would assume the Edge would not be as thick as the motors listed as compatabile.

    Anyone hooked up the 360 to the Edge. Any modifications if you did? I would think I could use inner tube to wrap around the trolling motor to make it thicker.

    I have an ranger 188, with 70lb Edge trolling motor.

    Joe from Virginia

  2. Member Wayne P.'s Avatar
    Join Date
    Jan 2010
    Location
    Charlottesville, VA
    Posts
    30,313
    #2
    If the Edge upper shaft is the same diameter as a Motor Guide Tour, then Transducer Shield and Saver has an adapter for the Fortrex version 360 or MEGA 360.
    Wayne Purdum
    Charlottesville, Va.
    Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
    SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
    MEGA LIVE, LIVE TL