I ordered my console middle of September, Picked it up at Rocklin BPS here in December, went to install it last night. I could not get it tight It still wobble. I removed it and seen two small keeper nuts that were not seated properly creating a gap between the console and the large bolts' not letting the black rubber pads seat flush with the console. The bolts for these small nuts were cross threaded and I need to buy new bolts to replace these. The large handle on one of the larger bolts the hold the console in place, came off in my hand, there is a set screw that was loose. There is a blemish on the console right below the glove box door, I will polish it out. The console came without the Z20 decals, had to order these on the side. Paid $1100.00.
I guess someone was a little careless at the factory when fabricating the console. Other than that the console matches the colors. Glove box is huge
Anyone having issues with the console?
Just venting a little, thanks
The guys at Rocklin BPS were great, this issue is not on them.