Originally Posted by
Valedhines@netzero.com
I recently had to replace the lower unit on my trolling motor due to brush card frying,could not just purchase card so bit the bullet and replaced unit,anyway after installing went to test motor and nothing,checked for 24 volts at receptacle ,no voltage then ohmed wires from batteries,had continuity through pos but not neg,now here is the issue the neg is spliced into another wire which I'm assuming is wire to a breaker or fuse.I cannot locate where this wire runs to as it is under deck .I have checked breakers on console none of them are tripped and also ohmed those out.I bypassed that wire and sent 24 v directly to new unit and runs fine,but I really don't want to bypass any safetys I just need to know where that splice starts also any wiring diagrams on a 1993 Gambler Intiminator would be greatly appreciated thx in advance for any info.