Thread: Trim sender

Results 1 to 2 of 2
  1. 11-21-2021, 05:40 PM #1
    XMP
    XMP is offline
    Member
    Join Date
    May 2019
    Location
    Rogersville, Tennessee
    Posts
    139

    Trim sender

    115 pro xs ct sn 2b489799. The trim gauge is on the 1/4 up mark when the engine is all the way down. Is there any adjustment to calibrate the gauge?
    Reply With Quote Reply With Quote
  2. EuropeanAM
    EuropeanAM is offline
    Mercury 3L/4 Stroke/Verado Moderator EuropeanAM's Avatar
    Join Date
    Apr 2008
    Location
    Greenville, SC (US)
    Posts
    95,178
    #2 11-22-2021, 03:16 PM
    If you are using an ANALOG trim gauge, there's really not any significant adjustment at the sensor. You MAY be able to remove it, reinstall it, and see some difference in the reading.

    It may also be possible to improve this by removing the tri-lobe pin, rotating the cross-pin 180 degrees and then installing a new Tri-lobe pin.

    Keep in mind- if your trailer or the ground interfere with full-down travel, you won't reach full down on the gauge.


    Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
    Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
    Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »