Question I have a Verado 250 #1B120046 on a 05z21. I'm going to buy a hydraulic jack plate to replace a 6" manual and was told that Ranger recommends a 10". Someone told me that the motor itself sets back four inches therefore I need a 6" plate. Does that sound correct? Any help appreciated
Last edited by prairiecreek; 11-24-2021 at 10:32 AM.
You are correct- there is already approximately 4" of setback built into the Verado 250 (of that vintage). 6" (such as the HD Atlas) would be a good choice.
If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info (serial number) when posting. Thanks!
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
I run a VRod and use a Atlas 6 inch
JEFF MURRAY USMC
RANGER Z521C & 15 VERADO PRO 250
DEEP CREEK LURES and ROSE JIGS
GREENFISH TACKLE and ALX RODS
Sorry about that. I corrected it
Reply With Quote
