2022 SKEETER ZXR21 4 BLADE PROP RESULTS
2022 Skeeter ZXR21 Dual Console 250 SHO Dual Raptors Hydraulic Jack-Plate. 45 Degrees out 387ft above sea level estimate 5in chop. 1 Person Light-Medium Tournament Load Half tank of Fuel.
Bravo1 LT 25P all solid PVS Plugs (might need 2 solid 2 small). Holeshot had smooth connection with little bow rise, before coming off plane you could run as slow as you want with just about ZERO porpoising. This boat turns like an animal as it is but now paired with this prop it was giving extremely planted feel with no fight on turns up to 70mph+. The Bravo1 LT is focused to lift Bow and Stern so with Jack-Plate floating between 11-13 and in between 3/4-Full Trim 73.1mph @ 6100rpms. The boat felt more level rather than nose up all around was a great prop for the boat. The FS will do great as well.
Next ran an Evinrude RX4 24P Vent Ports Closed Off running in same conditions.
Holeshot was about the same as the Bravo1 might have been a touch quicker to plane same goes for the low plane speed go as slow as you want before coming down with no porpoising.
This prop really elevated the bow of the boat but loosened up the rear so the boat was completely stable but had a nimble feel was very neat. High speed turns comparable to the Bravo LT also. With the Hydraulic Jack-Plate running at 15 the best and about 3/4 trim 73.6mph @6000rpms.
If you are running heavy loads in your boat both of these props would do great. I think the RX4 will maintain those speeds better but for those running any higher elevation a RX4 22P and/or Bravo1 LT 24P-24.5P might be nice to keep that SHO running right up at the 6k mark.
The Hub Kit for Mercury Prop adapting to Yamaha is Quicksilver 835274Q1 FLO-TORQ II KIT FOR YAMAHA 150-300 HP 4-STROKE OUTBOARDS.
The Hub Kit for Evinrude Prop adapting to Yamaha is Evinrude/Johnson TBX Kit 177288.
Good Luck My Friends.
PM for any questions.
Reply With Quote
