Does anyone know the correct length of the four transom to jack plate bolts for a 2001 206. 8" Slide master jack plate if that matters... I ordered some from a BBC sponsor and they are 2 1/2" in length... that seems too short...? Maybe they thought I meant jack plate to motor?? Need to know before I get this project started, as I'll be doing it a couple hours away, borrowing a fork lift to support the motor... the bolt kit was $102.00, so not cheap! Also, was going to use 3m4200. Is there a benefit to using silicone instead? I'll be using silicone for the transom chrome trim and end caps. Probably going to get some Boat Life for that. Can't remember which of the two they offer is best. If my memory is right, there is one that is preferred over the other... While we're at it, is it 50 or 55 lb ft to torque the bolts?

Thanks in advance!!
Derrick