Results 1 to 3 of 3
  1. #1
    Moderator Fishysam's Avatar
    Join Date
    Oct 2016
    Location
    Jamestown North Dakota
    Posts
    9,318

    Re-Finishing leading edge

    Let's say I have two stainless steel props 1 I don't care about and one I do, basically in the same condition (3 light nicks on the leading edge, probably from floating bark 4" long) is there a way I could work the prop I don't care about just to clean up the edge? Then if it turns out I could repeat it on the good prop
    Mercury 250 proxs 2B115089

  2. Moderator 21XDC's Avatar
    Join Date
    Sep 2004
    Location
    Westland Michigan
    Posts
    63,351
    #2
    I never sell or work my best prop... Until I get one I like better.

    Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html

  3. Moderator Fishysam's Avatar
    Join Date
    Oct 2016
    Location
    Jamestown North Dakota
    Posts
    9,318
    #3
    Like these knicks are so minor I almost think a brass hammer in like 6 oz would have enough to move the stainless steel enough to repair them. And I know brass is less stiff than stainless