Results 1 to 2 of 2
  1. 10-10-2021, 04:27 AM #1
    Jasonrs
    Jasonrs is offline
    Member Jasonrs's Avatar
    Join Date
    May 2009
    Location
    Wixom Lake, MI
    Posts
    3,101

    Proper way to set trim on smart craft?

    What is the procedure for this? Is this something done while on the water, or can it be done on the trailer? I followed instructions on screen, but now my total trim range is only like 3 before it goes into trailer and raises above the trim rods. Thanks
    Reply With Quote Reply With Quote
  2. EuropeanAM
    EuropeanAM is offline
    Mercury 3L/4 Stroke/Verado Moderator EuropeanAM's Avatar
    Join Date
    Apr 2008
    Location
    Greenville, SC (US)
    Posts
    95,258
    #2 10-11-2021, 12:53 PM
    If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info (serial number) when posting. Thanks!

    You are configuring ONLY the instrument. Has no affect on engine function.

    Enter the trim calibration.

    Run engine full DOWN and stall against DOWN for 4 seconds.

    SAVE as the DOWN position.

    Run trim to end of trim rams (short rams... just before "faster" operation begins).

    SAVE that position as the TRIM position.

    Run full UP to highest safe trailer position.

    SAVE that position as the TRAILER position.

    Leave the Trim Calibration settings.

    Note: Recommend your setup for "Trim Popup" and if given a choice, "Use High Resolution Trim".


    Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
    Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
    Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »