14-1/2x24 raker or comparable

[Bill in Pa]

Looking for an original Raker 14-1/2x24. On 1998 Stratos 295pedc with a 200 Evinrude Vindicator. Anything comparable. Looking for lift and a little in hole shot. Ran a renegade for a while but I can’t get on pad because there is no top end lift.

[21XDC]

Mark Croxton makes a Razor3 that is like an original RAKER with a flo torq hub and PVS holes.... His contact info is in the bottom of my posts.

The Merc Tempest Plus is another good choice.

[JR19]

I have an original Raker 24 and a Raker II 24 and they are darn near identical in rpm and overall performance. I will give the original Raker a tad better score on holeshot. I sent my Raker II to Mark and had him change the PVS holes to match the Mercury PVS system so I could fine tune my hole shot. With one hole open and two holes with a large plug my hole shot is currently almost identical to the original Raker. Without the mod it was a tad bit slower on holeshot.

[charg295]

The new Raker HO is a good prop with a lot of lift. it also has adjustable holes to tune your hole shot. I have one on a 200 and really like it.