Results 1 to 3 of 3
  1. 09-25-2021, 01:56 PM #1
    W.Pinciotti
    W.Pinciotti is offline
    Member
    Join Date
    Sep 2021
    Location
    Honey Brook Pa.
    Posts
    2

    Prop to pad height

    Hey guys I have been trying to find this out for awhile and no luck. I have a 2017 Lowe 195 stinger with a 115 Mercury on it if any one can help with the proper Prop to Pad height i would really appreciate it,
    Reply With Quote Reply With Quote
  2. Smallie_Hawgin
    Smallie_Hawgin is offline
    Member
    Join Date
    Dec 2019
    Location
    Rice, MN
    Posts
    360
    #2 09-27-2021, 06:58 AM
    Setback can affect the PTP. The more setback the higher you can go. Most rigs tend to have a PTP between 2" and 5", depending on setback amount. Each boat can have a "sweet spot", especially true for tin rigs where it isn't molded fiberglass. Imperfections in the welds exist and can make things different.
    Reply With Quote Reply With Quote
  3. W.Pinciotti
    W.Pinciotti is offline
    Member
    Join Date
    Sep 2021
    Location
    Honey Brook Pa.
    Posts
    2
    #3 09-27-2021, 02:50 PM
    Thank you, My motor is set all the way down on the top holes, after buying the boat new I found out that the dealer is not that good with doing stuff right it seems like the easiest way to take care of this is with a manual jack plate. Thank you again
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »