I have a Solix with a heading sensor on the bow. The icon is set to on heading up, but the line is based on the COG. How do I change that to be the heading line?
I have a Solix with a heading sensor on the bow. The icon is set to on heading up, but the line is based on the COG. How do I change that to be the heading line?
TRB
2016 Skeeter ZX 250
Minn Kota Ultrex
Helm: HDS Live
Bow: HDS Live with AT1
Heading is separate from Course (lime green line).
GPS does Course and a Heading Sensor (compass) does Heading.
When a Heading Sensor is detected, it controls the position icon (boat symbol). You can add a Heading Line (orange) in the Chart menu settings:
Chart Options
General
Vessel
Show/ON
Hdg
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
You can actually have both of them on and that can be helpful to be sure that the heading sensor is perfectly aligned with the boat. I leave both lines on and so the lines should be one on top of the other when going at enough speed for GPS to be accurate. If they are not, you can use the Heading Sensor Offset in the Networking settings to correct the heading sensor line. Once that is complete, then turn off the GPS line and leave the Heading line on... As per Wayne's instructions above.
---> Regards, Steve Yarbrough (AKA: SLYDoggieTN on YouTube)
- Apex 19/16/13, Mega 360, and Mega Live
- Minn Kota Ulterra Quest Trolling Motor
- (2) Cannon Optimum Bluetooth Downriggers
- Impulse Lithium Batteries... 36V 60AH for Trolling Motor, (2) 12V 120AH for Cranking & Electronics, 12V 60AH for Downriggers
TRB
2016 Skeeter ZX 250
Minn Kota Ultrex
Helm: HDS Live
Bow: HDS Live with AT1