Results 1 to 2 of 2
  1. 09-08-2021, 08:14 AM #1
    BTK301
    BTK301 is offline
    Member
    Join Date
    Sep 2021
    Location
    Madisonville, Tn
    Posts
    12

    EVINRUDE 150 INTRUDER

    Good day all. I am new to this site and hope I am posting this under the proper topic. I recently repurchased a 1995 Bass Boat that I originally bought new in 1995. It has been repowered with a rebuilt 1996 Evinrude 150 Intruder. I am trying to reconnect the water pressure gauge I originally installed when I purchased new but cannot figure out where the port/plug is on this motor to connect it to. Evinrude support is nearly nonexistent these days since they are no longer in business. If anyone has any input regarding this please weigh in. Thanks to all.
    Reply With Quote Reply With Quote
  2. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,276
    #2 09-08-2021, 11:36 AM
    The port for the water pressure gauge is on the center of the cylinder head. Look for a brass screw in hex head plug. Remove one of them I suggest using the port head as it is an easier to run the hose to the dash.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »