Page 2 of 2 FirstFirst 12
Results 21 to 30 of 30
  1. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #21
    Laughing out load. I didn't think it would be that easy. Ok, ok. Thanks again for the help.

  2. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #22
    I took the box apart finally. These are the parts that are damaged:
    #29
    — 397272 — SHIFT & THROTTLE PLATE ASSY.
    I tried to upload pics but it is not allowing. file too large.

  3. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #23
    Not sure why the plastic broke. With cable disconnected from both ends: I can move cable from both ends by hand easily. I can shift the gears with the shift arm on engine while spinning the prop with my foot. Going to try new plate and shift arm in the side mount controller.

  4. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #24
    Put new plate and shift arm in today. Changed gears good while spinning prop. Water test tomorrow hopefully.

    I shifted without spinning prop when I removed LU and I think that is what probably initiated or completely caused the damage. Expensive lesson.

  5. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #25
    Not able to go out on the water today. I did put it on muffs though and it shifted good. Thanks for the help

  6. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #26
    Hello everybody,
    Finally did get my boat running good. Replaced flywheel magnets, stator, power pack, vacuum switch, and other smaller items. I still
    couldn't get to start and so I did take it to a mechanic. They replaced the VRO and there was a carb issue. But I am not sure still why it wouldn't start.

    So now I have a new unfamiliar item. There is white plastic pieces just inside my water intact holes on the LU for the water cooling system. Does anybody know what they are?
    ChampioNman has pointed out that I have an older LU swapped to my outboard so I don't know the part number to look up.

    Thank you
    j200txedr

  7. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,248
    #27
    More than likely the water intake screens behind the inlet.

  8. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #28
    Thank you ChampioNman,

  9. Member
    Join Date
    Jun 2021
    Location
    Jacksonville, FL
    Posts
    55
    #29
    This?
    0321123 Johnson



  10. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,248
    #30
    Yessir.

Page 2 of 2 FirstFirst 12