I have a 2010 P2. I need to replace my fuel lines. Anybody know how to access the fuel tank under the seats? Also, anyone know how many feet of fuel line I need to order? Thank you.
I have a 2010 P2. I need to replace my fuel lines. Anybody know how to access the fuel tank under the seats? Also, anyone know how many feet of fuel line I need to order? Thank you.
I have the same boat, 2010 PII. I haven't had to access the fuel tank but I have removed the seats and I think there is a fiberglass cover over the tank that you can remove. I remember seeing some screws holding it down...
Rob Ridge
www.folsombassteam.com
2018 Nitro Z19 Pro, 200 Mercury Pro XS
Not same boat but basically the same length. 13 P4. Ironically I am having the same type engine problems you posted on the Merc page. I just replaced my fuel line to the belly tank and what I pulled out was 12ft. I taped some wire to one end of the fuel line and pulled it through. Then pulled the wire back with the new line attached . Was kind of tight so I wet it a little.
I had to pull the back of the seat cushion up towards the front to access the 4 screws. Two under bottom of seat and two right under the backrest. After that there was just a lot of screws holding the fiberglass lid over the tank. But yours could be totally different?
2013 Pantera 4
2012 Opti 200 Pro XS
25 Tempest
I have done it. Remove the seats with their brackets first. You then will have access to about 15-20 screws that will allow you to remove the entire shelf that the seats were attached to. It is not heavy but is bulky. If you have torun new transducer cables, now is the time.
I forget whether I needed to loosen the throttle assembly and move it forward. I do not think I did though.
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s