No spark

[.44mag]

OG724176
I have no spark at any of the plugs when I spin the engine over. Can hear the fuel pump in the vst running. 20210623_143721.jpg
This power head came with cdi electronics, so are these the green with white and white with green that I start my checks with for clarification.
20210623_143909_1.jpg Also where they go into the stator they are loose. Every thing else looks ok from what I can see. Last time I used it while I was on the way back to the ramp it "cut out" three to four times. I slowed down after the first one, luckily I was at the no wake zone for my ramp when it died as I was coming off plane. Compression is 118 to 120 on all 6 but that is cold check. Last year when I checked the compression on it at temp it was 120 on all 6.

[JOE54]

yes /those are stator wires , eliminate key and kill switch also as problem

[.44mag]

Ok. Will look up the key and kill switch part. The two wires ohm out at 431 between the two. I know resistance will increase with heat correct?

[.44mag]

yes /those are stator wires , eliminate key and kill switch also as problem

20210624_132201.jpg
Found the problem. Glad I had another one on hand. Should I redo the sink and link? Trigger wasn't touched.

[JOE54]

prob not needed but wouldnt hurt just to verify good running quality