I confirmed this is an elevation/altitude issue, so I am now working to test 19P prop that I got from the local shop.
I just installed it with the Flo Torq II kit and it feels as if the prop has too much slop or I am missing a step. I followed the Flo Torq instructions, but I am left with a splined washer that is not shown in the instructions.
2006 Etec 225
Model Number - E225DPLSUA
Serial Number - 05161140
Prop I am trying to install - Power Tech! Pics contain the model number
Flo Torq II - 8M0119081
Pictures attached. Will this prop work with this motor? The castle nut seems to be on too far, but at the same time it feels it needs to be tighter. Am I missing where this splined washer goes?
My current prop is a Cyclone with a built in hub, so this is my first time with a hub kit.