-
Power Pole QuestionThis morning
Coming home from Lake yesterday port power pole had dropped about 6 inches. This morning it was in the pocket but when I pulled it moved a few inches out. Any help please. Thank you.
-
Sounds like a valve inside the pump is not fully seating allowing psi to bleed off over time. This would be the first place to start. Depending on what model Power Pole you own you have 2 choices.
Stealth Pump system - remove pump and send to Power Pole to be serviced, cleaned, flowed, etc.
CM1.0 or CM2.0 - Contact Power Pole and they can send you a set of Pre-Set valve bodies which you can swap out yourself. Of send the pump in for service.
Typically this is the issue. From time to time we may see a faulty cylinder however it is much more rare to be the cylinder.
Start at pump.
SIDE NOTE - If this is a new install with little use you could have a stubborn air pocket. Purge the air by fully cycling the cylinder in and out multiple times at different speeds. When the cylinder reaches full extension or retraction continue to hold the remote button for approx 30-45 seconds to help cycle fluid in turn pushing air through system.
Any questions feel free
Rich 954-917-0634