Help with Ghost Install

[skywayvett]

Got the Ghost mounted on a 1991 Hydra Sport TS ,But the stabilizer bar won't be on the deck its hitting right on the topcap ?
Any suggestions on how to make this work.
Thanks John

[skennedy]

Try and send a picture . But most need to be shimmed up a 1/2 inch

[NoCAL]

Must be an exceptionally narrow front end. Not sure there is anything you can do if that's the shape of your boat.

NoCAL

[wmitch2]

It all depends on the angle the the mount sets. I could have gone either way, but I didn't like where it hit on the deck. Would be right in the middle of my rods. Mounted mine on the outside. I plan on getting something for it to hit on rather than the top cap, but haven't found something yet, so I use a felt chair slide. This is from before I got the slide.

[Rip Bass]

Got the Ghost mounted on a 1991 Hydra Sport TS ,But the stabilizer bar won't be on the deck its hitting right on the topcap ?
Any suggestions on how to make this work.
Thanks John

You do know the bracket can be mounted on either side of the motor bracket?

[mikeky]

You do know the bracket can be mounted on either side of the motor bracket?

On mine the mounting hole is cast with the motor bracket.

[Crappie Bob]

Problem with Ghost, picture of Minn Kota, are they the same. Just asking

[BASS2277]

that is not a ghost tm

[e-tec]

I have been using my older T/M like that for years without any issues. You can buy walking cane tips that provide a little extra cushion if you prefer.

[secdawgs]

C444ADFD-ED8F-47C7-AF6C-94025A077E5F.jpeg12FA72DD-B772-4059-AC61-422A6777F8D1.jpeg
Had the same issue with the width of my boat, 1/4 aluminum from local fab shop and 2 part epoxy!