Has anyone on here replaced their domed boat model decal? My starboard side Pantera 2 decal has a chunk missing from it, and I was considering replacing it. Looking for any pointers before I begin.
Thanks!
Has anyone on here replaced their domed boat model decal? My starboard side Pantera 2 decal has a chunk missing from it, and I was considering replacing it. Looking for any pointers before I begin.
Thanks!
2014 BassCat PII
Mercury 200 ProXS
http://offthechartsboating.com
Just peel it up and remove the glue with some wd40 or adhesive remover on a rag. Then clean the surface with some isopropyl alcohol and use a 3m adhesive promoter wipe before installing the new badge. I've had them peel up on newer boats and just called bcb parts and had them send them out.
"the head, the tail, the whole damn thing"
peal the thing off, clean, install activator and stick the new one on. if ya cant remember where it went, box it out with tape so you know where to place the new one.
Getting the old glue off is the hardest part
I replaced both domed decals on my 2007 Sabre FTD. Frame the old decal along the bottom, and either end with blue painters tape. Follow the instruction above to remove and install the new one. It was very easy with the tape as a guide.
BassCat Sabre FTD
Mercury 150 Optimax
"It's just fishing"
Thanks everyone for your input!
2014 BassCat PII
Mercury 200 ProXS
http://offthechartsboating.com