What would ya'll recommend to repair a hole caused by the divider bouncing around. Live well walls are plastic.
Thanks
What would ya'll recommend to repair a hole caused by the divider bouncing around. Live well walls are plastic.
Thanks
I'm going to throw out a guess only of 3M 4200. Curious to know what the good folks here think.
2004 Ranger 519VX
Yamaha VMAX 200HP OX66
Duc(t)k tape.
A pic would help. I'd be leaning toward a fiberglass repair kit.
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
flex seal , saw it on the infomercial this morning.
but seriously if it is leaking around the fittings, maybe loosen them and add some silicone sealer and retighten, if it is a crack, then the fiberglass kit will be the best and most permanent solution.
4200 or 5200 the holes/crack if they are small, otherwise fiberglass repair kit.
But he said it made of plastic. Fiberglass kit will work on it.
Locktite has a product called Plastics Bonder glue.
6 months, so far so good.
Used it to glue some plastic tubing inside another plastic tube.
Can't find the packaging that listed the plastics that it works on.
In the glues section at Home Depot.
Good Luck
How about Marine Tex comes in different colors easy to mix and use should do the trick...
1990 374V Ranger Still kickin' bass after all these years