Results 1 to 3 of 3
  1. 04-19-2021, 07:31 PM #1
    dcalvert
    dcalvert is offline
    Member
    Join Date
    Jan 2015
    Location
    Mesa, AZ
    Posts
    33

    Helix 10 G3 install

    I am almost complete with my network upgrade on my rig. Installing a new Helix 10 chirp mega SI, Mega DI including network switch and all cables. I have existing Helix G3 mega DI up front and Uterra link trolling motor with DI built in.
    Just a few final terminations left. Assembling the Cable tray to Helix 10 Chip. Mega SI, Mega DI, I only have four cable connectors to install in it. There is no Temp/Speed temp as showing in the instructions. Not sure what I am missing.

    Respectfully,
    Dcalvert
    Reply With Quote Reply With Quote
  2. ezfishn
    ezfishn is offline
    Member
    Join Date
    Jun 2013
    Location
    Hemet, CA
    Posts
    4,659
    #2 04-19-2021, 08:31 PM
    The Temp/Speed slot in the connector tray is for a auxiliary sensor and not used unless you have one. You will get temp through the transducer and can get speed from GPS.
    Wes
    Helix 10 MSI+,MDI+,Ultrex IPilot
    2023 Phoenix 818
    Never assume there's a tomorrow
    Reply With Quote Reply With Quote
  3. dcalvert
    dcalvert is offline
    Member
    Join Date
    Jan 2015
    Location
    Mesa, AZ
    Posts
    33
    #3 04-20-2021, 06:33 AM
    Great to hear. i thought I had it all installed. Can't wait to wrap this project up.

    D..
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »