Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Jun 2018
    Location
    Syracuse NY
    Posts
    267

    Power Pole CM1 not going up

    The port side wont go up. After trying the foot switch and dash remote I went to the motor itself. When I push the up button the unit plays the power on chimes. I checked the fuse and terminal connection but they are good. Any suggestions on a solution or should I take a day off to call Power Pole cs?

  2. BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,937
    #2
    Swap board from starboard pump to port pump let me know result.

  3. Member
    Join Date
    Jun 2018
    Location
    Syracuse NY
    Posts
    267
    #3
    Well there we go. Swapped the boards and the problem switched sides. New circuit board needed?

    thank you

  4. BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,937
    #4
    Quote Originally Posted by Rick Howard View Post
    Well there we go. Swapped the boards and the problem switched sides. New circuit board needed?

    thank you
    be sure when you call powerpole tell them that you swapped boards and it fixed the issue they will get you a new board right out.

  5. Member
    Join Date
    Jun 2018
    Location
    Syracuse NY
    Posts
    267
    #5
    Quote Originally Posted by kandkkustomzhydrographics View Post
    be sure when you call powerpole tell them that you swapped boards and it fixed the issue they will get you a new board right out.
    much appreciated. Thank you.

  6. BBC SPONSOR/ Shallow Water Anchors Moderator
    Join Date
    Apr 2015
    Location
    New York
    Posts
    10,937
    #6
    Quote Originally Posted by Rick Howard View Post
    much appreciated. Thank you.