Can anyone provide the maximum and minimum center to center distance for the bolt holes for mounting the Raptor bracket to a jack plate? I am trying to figure out if I can mount them on the side of my jack plate, and I am worried the bolts on my jack plate are too far apart. I have attached a picture showing what dimensions I am looking for.
Thanks!
What jackplate is it? I can get measurements tomorrow, but they will fit pretty much every jackplate out there
1999 Triton TR-19 PDC
1999 Mercury 175 EFI
25P Tempest Prop-worked by Croxton
Minnkota Ultrex 80
Humminbird Helix 9 MDI Bow
Humminbird Helix 10 Mega SI Bow
Humminbird Helix 10 Mega SI Console
Humminbird Helix 5
Humminbird Mega 360
Mega Live
8in Vance MFG. jack plate
2 10ft Minnkota Raptors
The jackplate is a TH Marine Pro Hi-Jacker EZ. Not a whole lot of information out there on them. They swivel up and down instead of sliding and the bolt holes for the swivel points are pretty far apart. Drilling another hole may be an option, but i'd rather not if I can avoid it. I would also rather not use a sandwich bracket if I can avoid it. Thanks!
Your best bet is to call Min Kota or TH marine. they should be able to answer your question. More so TH Marine.
Reply With Quote