So what years does this part # fit any idea? I have a 2019 Z520L and when I order I want to make sure this will fit my boat. Nothing against Ranger parts, but if i can bypass I would rather just call a dealer with a part #
Thanks
So what years does this part # fit any idea? I have a 2019 Z520L and when I order I want to make sure this will fit my boat. Nothing against Ranger parts, but if i can bypass I would rather just call a dealer with a part #
Thanks
Last edited by jc2bg; 04-05-2021 at 03:07 PM.
Ranger 518 dvx!!
Part number is on the package in that first pic on the 1st post in the thread. Have to check with your dealer (or Ranger) on compatibility.
To reiterate, it is not necessary to tell a Ranger dealer what part number you want. The dealer will look up the right part number for you in the Ranger system, based on your hull ID and your description of the desired part.
John Clark — Findlay, Ohio
Thanks
Ranger 518 dvx!!
Nice video. I purchased my auxiliary key switch when I picked my new Ranger up from the dealer.
I wonder if this switch will work on a 2008 Z21 with a Mercury Optimax Pro XS 2 stroke?
John Clark — Findlay, Ohio
Thanks ! Going to get one....Always good to have a backup plan.....I don't like getting towed in. lol
Hey can someone do me a favor. The deutch plug on the boat side. Can someone follow it back a little ways and see if there is an adapter to the merc harness?
2011 Ranger z521/2023 250ProXS
Make certain you have a T20 driver tool to take the key pad off ....
2020 - Ranger 520L Midnight Fox | Mercury 4S 250 - Go Boldly! | Atlas Jackplate | Ultrex | Lowrance Active Target | Power Poles !!
No need to take the panel off to plug in the key switch assembly.
You do have to remove the keypad on an L boat.
2018 Z521L 250 PRO XS V8
Thread sticky worthy?
Best online store to order the part?
Jon
2013 Ranger Z520C
2013 Mercury 250 ProXS
I have a 2010 Ranger 620 VS with Evinrude 250 HP H.O. Etec. When I installed the key switch assembly It doesn't start the Motor. I get 12 Volts at the Keyed ignition but it doesn't start the motor. The Brain box flashes red then green? Anyone have an issue like this before ? When I plug the connector back into the Key pad the motor will start like normal ?
Correct connector ?
should have this color wires 47621BEB-30D2-4479-8CA2-1C13BE7C4A1F.jpeg
2011 Ranger z521/2023 250ProXS
Thank you so very much ! The yellow wires were the what I was missing ! I was unpluging the connector right behind the start &stop buttons. Tried it on the connector with the yellow wires and it started right up ! As soon as I unplugged it it looked just like your picture. Tight Lines & good karma coming your way !
Thanks! Will get one ordered! Greg
Just had a keypad fail, was able to find one on ebay and I also ordered the switch.