Active Target pretty awesome

[buckmaster27012]

are you using ghost or ultrex? didnt know if that made a difference. thanks

I had to re-calibrate the Point-1. It required getting into the Point-1 calibration page and then turning the boat in a circle until it locked in. Do a search for Point-1 calibration. After that the direction indicator did work but it wasn't perfect. With wind blowing the boat around it had a little trouble keeping track of direction. It was close though and not all over the place like before the calibration.

[FeFanatic]

I am using a Ghost. It doesn't matter since the live target is syncing on the Point-1.

[96MrBass]

Lowrance units can't read SD cards over 32MB (I think) so make sure you are not using one too large.

Thanks for the heads up. I got it working with a new card.

[buckmaster27012]

calibrated the point 1 when i got on the water yesterday and no change to my active target cone. i've read about changing the heading offset but i dont see that as an option once i go to the page. i'm not sure if that only works with a ghost or what. does anybody know? thanks

[Roadhog56]

calibrated the point 1 when i got on the water yesterday and no change to my active target cone. i've read about changing the heading offset but i dont see that as an option once i go to the page. i'm not sure if that only works with a ghost or what. does anybody know? thanks

I am running the Elite FS, try Settings, Sonar, Activetarget installation and the offset is located on that screen.

[mikeky]

I have my forward range set to 40' and can see a crappie jig that far. Will show the line from a marker buoy from surface to bottom.

Even swam the jig past a few crappie and saw them bite.

[rock2033]

I have my forward range set to 40' and can see a crappie jig that far. Will show the line from a marker buoy from surface to bottom.

Even swam the jig past a few crappie and saw them bite.

Must be nice! LOL.
I cant see anything past 15ft.

[AlumaPro]

I have a question? StabbleView enable or disabled?

[SAL321]

I have a question? StabbleView enable or disabled?

Based on most of the feedback it should be disabled.

[mikeky]

Based on most of the feedback it should be disabled.

What does it do?

[DewRonInc]

control bouncing up and down in waves

[New2Fish]

how do you sync whit the point one when gps doesn't work under water?

[W W]

Received mine from Tackle warehouse 2 weeks ago All is good, 1 thing was a issue I used blue loctite on the trolling motor nuts (no nylon loc) it broke down the plastic mount (don't use it) for the latest transducer update I downloaded it to a sd card then uploaded it to the module (no problems at all. I can see a 1/2 Oz spinnerbait and both tandem blades at 20 feet out and the bait in general at 40 ft in 12 fow, fish marks are clear great for in forming you of lure running depth (crankbaits). The day I tested it the wind was a steady 15mph gust of 30 I had 2 10' p.p down and the motor guide on anchor mode. I can't wait to see what it can do on a calm day. Another thing I would avoid is if you have multiple hhead units networked (ethernet) is to run the data cable from the head unit that's viewing the active target to the module not to another unit 1st, if you run it to another head unit and share across the net you can't turn off 1 of the units (only use standby) or you will show a no source on the unit you are viewing the active target on.
Enjoy Warren