Are 835257A1 and 835257K6 interchangeable as far as props go? Would the A1 part# be the 55 ft lb torques spec and the K6 be the 100 since A1 has no front bushing in the insert just an empty cone?
Are 835257A1 and 835257K6 interchangeable as far as props go? Would the A1 part# be the 55 ft lb torques spec and the K6 be the 100 since A1 has no front bushing in the insert just an empty cone?
yes but i would add the bushing even to the A1, the k6 is suppose to be used on surface piercing setups which most hi perf bass rigs are when set up right
.................................................. ...the scariest thing in life is the unknown ...................................
10-4. Thanks Joe!!! Will use the k6 and leave the A1 in the boat as emergency spare.
The parts of the A1 are essentially identical- it's just not equipped with the "conical filler sleeve" that seats against the thrust washer.
Dual Mercury Master Technician- for Mercury Outboards, Mercruiser and Mercury Racing at European Marine in Greenville, SC.
Still consider myself a "Marine Apprentice" after 47 years (learn something new every day).
Mercury Parts, Mercury Outboards, Smartcraft & Accessories, Injector Service, TDR Reeds- BBC Sponsor
Thanks Don. We would be lost without you and Joe and we are appreciative of your willingness to share your time and knowledge.