Vessel View Mobile

[swamprat]

2021 175 ProXS ser.#3B008638
I purchased and installed a vessel view module a few weeks ago.I like the concept,but I am disappointed with it with it,,,I can't get it to stay linked to my motor.Always having to reconnect.
Any ideas??

[Benz819]

Did you mount the module up as high on the motor under the cowling as you can? I know that will help. I actually had to download a app on my phone that helps boost the phones Bluetooth capability.

[JS!]

This is how mine is mounted and I have zero connectivity issues. It is zip-tied to the wiring below it nice and snug. Make sure it is not near any High Voltage Ignition Leads.

PXL_20210123_004123737.jpg


On the phone side, I would try this:

Delete the app, delete any old unused saved bluetooth devices from the phone, restart phone, re-install the app. Follow the directions step by step in the VVM manual and app.

Hope you get it working.

[EuropeanAM]

Since that's a V6... you can usually bring the module up to the top of the engine, and route it as far forward (up high) as possible. Helps if you leave the 10-pin connector (where terminating resistor originally was located) off it's gray hanger-clip, to gain a little more flexibility.

Another alternative is to order and install the components of a Smartcraft Network, relocating the module at the helm (and providing this best/cleanest connection you're likely to get). If you want to look at this option, see Rhonda's post (pinned at the top of the Forum), and drop her an email.

[swamprat]

Thank yall for the ideas We ain't done messing with it.

[moymurfs]

I relocated mine up to the helm. Just plugged it in to an unused port on the j-box.

[mkm]

I have a 175 also. Below link is what Mercury sent me and I have no connection issues.

http://www.bbcboards.net/showthread....640&highlight=

[DaveTTN]

Get the blue cable from Don and run it to the helm and mount it under the console. Once I did that I have never lost connection.

[swamprat]

Blue cable ran all the way to the helm,PN#84-879982t20. Go to hook up V.V. module to the cable both ends female,,,WT Heck.Did I order the wrong BLUE DATA cable??

[06 SB]

You need more than just the cable. You either need a junction box or a gender bender adapter. Were you clear about what you were trying to accomplish when talking with Rhonda when you ordered the cable?

[EuropeanAM]

Did you purchase that cable from us?

[swamprat]

I did not Don,,,and it sounds like a lesson learned...oops

[EuropeanAM]

As suggested earlier, you'll need either a Junction Box, a "Y-Harness", or a Male-Male Junction Adapter.

Junction Adapter is the least expensive option, if you have ONLY ONE Smartcraft Device.

[swamprat]

As suggested earlier, you'll need either a Junction Box, a "Y-Harness", or a Male-Male Junction Adapter.

Junction Adapter is the least expensive option, if you have ONLY ONE Smartcraft Device.

Thank you Don..I only have the vessel view mobile.. I will call or email Rhonda and order the junction box.Will she have the part # I need Thanks.

[EuropeanAM]

She will have the necessary part numbers (as your Parts Specialist).

[swamprat]

She will have the necessary part numbers (as your Parts Specialist).

Thank you I have started the process to get with her

[swamprat]

She will have the necessary part numbers (as your Parts Specialist).

junction box ordered from Rhonda,thanks