I have a 2006 210 with a 2006 250xs. I am currently running a 10in CMC hydraulic jackplate. I am looking at either an Atlas or a Bob's. I am seeing 12in cheaper than 10in. Would the 12in give better holeshot and stability or should I stick with the 10in models? Any difference between Atlas and Bob's on the 210? Thanks!
I doubt the holeshot will get better but the top end would be a bit better with the 12 vs the 10. IMO neither plate would be any different than the other.
Why are you replacing the one you have now?
I am pulling my motor to put Talon brackets on behind the jackplate. I figured I would upgrade while I have it pulled. I think it will be faster going up and down also. Thanks for the reply!
I ordered a Bob's 10" Set Back.
Good choice.Originally Posted by ryant57
2020 Triton 18 TRX
Tournament Fishing Package
2020 Mercury 200 Pro XS V8 Serial # 2B588923
Minn Kota Ultrex 80# I Pilot Link
Hi Jacker EZ 6" Jack Plate
Bravo 1 FS 24 Pitch Prop
Humminbird Helix 7 SI GPS CHIRP G2 Bow
Humminbird Helix 7 CHIRP MEGA GPS DI G3 Console
Trick Step Boarding Steps
RMP Engine Support
Reply With Quote