Has anyone had an issue with the deck layout on the newer ZX/ZXR creaking when you put weight on where the crease is at the very front of the center lids? Trying to figure out a way to resolve the issue, any help would be appreciated, thanks.
Has anyone had an issue with the deck layout on the newer ZX/ZXR creaking when you put weight on where the crease is at the very front of the center lids? Trying to figure out a way to resolve the issue, any help would be appreciated, thanks.
I remember seeing 1 post of an owner that stated the same problem.
In the end, he added a seal on the lid and that silenced it.
I believe it was a thin foam single tape side he used.
Good Luck!
Last edited by OK_BassBum; 02-16-2021 at 01:39 PM.
Look at trolling motor pedal trim ring. The plastic trim ring that is screwed on top of the trolling motor pedal well. Mine was creaking around that. I loosened the screws readjusted it and tightened the screws down and fixed the noise.
This. Put truck topper tape under your lidsOriginally Posted by OK_BassBum
Mike
Reply With Quote