-
Charger 496tf trolling motor
What shaft length is everyone running?
Also, the bilge compartment is pretty small, are most of you using 36v trolling motors?
Where do you put the batteries?
-
Charger Boats Moderator
24 volt on the 596 and a 54 inch shaft if you fish big water
-
Charger Boats Moderator
I run orielys group 34m agm they weigh 40 lbs and are about half the size.The 596 is a lot bigger in that area and I can put 6 of the 34m back there
Last edited by TOUCH OF CLASS; 02-11-2021 at 11:41 AM.
-
I ran a 24/80/52 ultrex on my 496 and never had an issue
-
Member
What part number at Oreilly's? All I see are the Optima's in 34 deep cycle.
I got nothin
-
Charger Boats Moderator
Jim where you been I thought you might of got sucked up by the shit pumper
-
Charger Boats Moderator
-
Member
I got nothin
-
Member
I saw that one but it says Start, so wasn't sure.
I got nothin
-
Charger Boats Moderator
Had mine for 2 years and haven’t had any issues and that’s on the ultrex on spotlock 80 percent of the time always working
-
Member
Good to know. I'm probably going to replace all 4 of mine when it warms some.
I got nothin
-
I run the Garmin Force 36V with 3X50AH Lithium batteries...The batteries are smaller than lead acid or AGM and much lighter. And with the Garmin brushless motor, I've never got the batteries below 70% after 3 days of solid fishing. Its a slick set up...
Lithium's have come down to a reasonable level... I went with Ionics 3 of these plus the charger https://drewcraft.com/product/50ah-1...thium-battery/
20200624_082545.jpg
-
I went with the 31 series AGM from Sams. They are 189.99 per battery and I have heard alot of good things about them.