Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Jan 2014
    Location
    Bluffton, SC
    Posts
    350

    225 Promax rigging tube options

    I'm getting ready to put my engine back on my 20XD and looking for pictures of different rigging options.

    My boat is stock with the big hole on the right side through which all the wires, fuel, hydraulic steering, and other lines come out of. I want to clean that up aesthetically as well as seal off the hole so that water and debris stops entering my bilge.

    So far I have a single waterproof gland for the transducer cable that will run down on the Jackplate, a dual hydraulic hose plate that will hold the steering hoses, and one Hardin marine swivel housing for a 2.5" rigging tube.

    I'm debating between single vs dual rigging tubes as well as if I'm going to stick with the stock location on the right or if I'm going to move the rigging to a more centered location.

    On my ProMax it would seem everything could be ran into the left hole on the lower cowling and I think that would look the best, but I'd really like to see some pictures of what you guys are doing.

    1993 Bullet 20XD
    2000 Mercury ProMax 225



  2. Member
    Join Date
    Jan 2014
    Location
    Bluffton, SC
    Posts
    350
    #2
    This is what I came up with so far.


    1993 Bullet 20XD
    2000 Mercury ProMax 225