Humminbird Ethernet box location

[woppercatcher]

For those of you with a newer model that came from the factory with the Humminbird Ethernet box where was it mounted?

Thanks

[Tyler82284]

Under the drivers console, above and a little to the left of the hot foot

[woppercatcher]

Thanks. So a ten foot Ether net cable should reach from the bow of a ZX225 to the box?

[OK_BassBum]

Not necessarily, you should measure the distance. It could come up short depending on your setup
and where your wires run.

[Pat Dilling]

In my 2021 Nitro it is at the back edge of the starboard rod box. Cables come through a conduit that runs up inside the gunnel.

[woppercatcher]

Thanks, guys. I'm hopefully going to get a new ZX225 and will be running two units at the bow and one at the console. So I'm just trying to figure out in advance what I will need that doesn't come with the boat. It seems the boat comes with the Ultrex IPilot-link along with the two graphs and Ethernet box and hopefully all of those are already connected to the Ethernet box. If that's true I believe I will need an additional Ethernet cable and adapter for my 3rd unit. To be safe I can get a 15 foot cable.

[rickmb]

Thanks. So a ten foot Ether net cable should reach from the bow of a ZX225 to the box?

I have two units at the bow of my ZX250. My switch is under the console behind and to the left to the left of the hot foot. A 15' cable barely reached. The ZX225 is a foot shorter in the front deck so a 15' would work. My other unit has the 20' cable.

[Gimpy]

Yea get the 15'. I have a 175 tracker that the 10' did not give much extra length.

[Gotsum]

I have ZX225 with 2 units on the bow and a 15 foot was just right with a little slack on each end.