Trolling Motor Repair

[RipBait67]

Is there a reliable TM repair shop in
central Arkansas?
Thanks

[Arkyarcher]

Jones Trolling motors in Texarkana

[RipBait67]

Thanks, I have a motor guide. I called them and was told they no longer work on them.

[rivertrail]

Pretty sure H2O in Sherwood has a trolling motor repair guy.

[lewsuser]

Pretty sure H2O in Sherwood has a trolling motor repair guy.

Trolling Motor Shop (Wayne Craig - owner)
Pine Bluff
870 534-4161
I have had excellent repair service and usually he repairs the same day I bring it in.

[RipBait67]

Thanks to all will be in touch with these places. Thanks again

[woppercatcher]

H2O and Jones are the only MinnKota ASC if that matters. I need to get my Ultrex repaired and called H2O and they are backed up for two weeks at least and Jones is backed up until next Wednesday when I'm going to tow my boat down to them. You might try the guy on 7 just south of the Village West gate depending on what you need fixed on your trolling motor.

[rockmike]

Trolling Motor Shop (Wayne Craig - owner)
Pine Bluff
870 534-4161
I have had excellent repair service and usually he repairs the same day I bring it in.

Highly recommend.

[Bill Reynolds]

Trolling Motor Shop (Wayne Craig - owner)
Pine Bluff
870 534-4161
I have had excellent repair service and usually he repairs the same day I bring it in.

It is best to call and make an appointment these days. I am 80% sure he is a Minn Kota ASC. One of my friends had his Terrova repaired there under warranty.

[RipBait67]

The issue I am having with my TM is interface with the front graph Garmin 93sv. Was told to have a grounding strap put in my Motor Guide 82# digital variable speed. Have tried everything that has been recommended to me. Maybe old motor and boat. Will try to get it to TM Shop.

[woppercatcher]

The issue I am having with my TM is interface with the front graph Garmin 93sv. Was told to have a grounding strap put in my Motor Guide 82# digital variable speed. Have tried everything that has been recommended to me. Maybe old motor and boat. Will try to get it to TM Shop.

Not much you can do with the trolling motor to stop interference unless the brushes are worn out. I would post your interference issue on the Garmin forum and you should get plenty of suggestions there.

[JTS]

Try Grizzly Jig Co 1503 S Truman Blvd, Caruthersville, MO 63830.... They have worked on my TM while I waited

[RipBait67]

Thanks to everyone for their help,
the TM worked fine but to much
interference have sold it thinking
on what I need in new one.
Thanks again

[Bill Reynolds]

The issue I am having with my TM is interface with the front graph Garmin 93sv. Was told to have a grounding strap put in my Motor Guide 82# digital variable speed. Have tried everything that has been recommended to me. Maybe old motor and boat. Will try to get it to TM Shop.

This may be helpful, I created it for an out of town friend. It is best practices to reduce or eliminate interference on 2D sonar.
I will say that another friend had a Garmin unit and we did everything possible and could not eliminate the interference on down scan.

[RipBait67]

Thank You Bill Reynolds I appreciate it and keep that in mind as I haven’t decided on what I’m going to get. Looking outside I think I have plenty of time to think about it. Thanks again