I’m hearing a popping noise when trimming/tilting my 2002 40hp Mercury. Is does it more when going up but also makes the same noise when going down. Any thoughts/ideas?
I’m hearing a popping noise when trimming/tilting my 2002 40hp Mercury. Is does it more when going up but also makes the same noise when going down. Any thoughts/ideas?
got 3 three ram system ?????? may need grease on balls and trim striker plates
.................................................. ...the scariest thing in life is the unknown ...................................
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
does noise sound like its comming from tilt or steerring tube dry ?????
.................................................. ...the scariest thing in life is the unknown ...................................
Low fluid will make noise and pop as the air gets compressed. Most tilt/trim units are good for 10-15 years before seals etc wear out.
Please release me,let me go.
Tilt tube seems well greased. I went check it again and when I put my hand on the trim motor, it feels like it’s coming from the motor. It still trims and the fluid was full and clean. The outside of the motor housing is pretty corroded so I’m guessing the motor is close to going out.
most likley, salty environment could do that
.................................................. ...the scariest thing in life is the unknown ...................................