Humminbird heading sensor on a F205

[trainspotter]

Hey i'm looking for advice. Any of y'all running Humminbird's with heading sensors. I am trying to figure out where to mount the puck on the front and back of my F205. Both pictures have 3 red dots where i have seen them on other bass boats. Where's the best place to do this? Thanks in advance.

[figueira]

should be as close to the transducer as possible
that way its more accurate

[kry29]

Check the locations for magnetic interference but if you are using it as your GPS position to you will want it as close as possible to the transducer you are using it for. I'm not sure on bird, but on lowrance theres how I set it up, i put the point 1 at the back of the boat nearest the transducer as i can without interference and set the console graphs to use it for heading and position. Then i set the front graph to use the units internal GPS for position and the point 1 just for heading. That way each units position is as close to the transducer as possible