Any suggestions its a ZX190 Skeeter I have to repair some gel coat chips in haul and don't know what may be under the bunks
Any suggestions its a ZX190 Skeeter I have to repair some gel coat chips in haul and don't know what may be under the bunks
There is other ways to do it but if you buy 2 Brownwell boat stands for the rear and a Brownwell keel stand....that’ll do the job “safely” but a little pricey. We use there products in my shop.
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
Even with my overhead lift I do not get under a boat unless it is on fixed stands.
I have used a combination of floor jack and jack stands with large dimensional lumber to hold up my river boat for a wetlander application on the hull. I also used jack stands and lumber to hold the transom as I used the floor jack on the keel area, then rolled the trailer forward on the X19 for pad work. You can do it with four jack stands and some maneuvering.
Read this thread. Pay attention to the post I made. It works great and is safe if you use common sense and support the bow.
Good Luck
Lifting a boat off a trailer (bbcboards.net)
22R
Allison XB2002 / Merc 150 XR6
Thanks guys for input supporting stern on the jack plate was my plan