Results 1 to 7 of 7
  1. #1
    Kentucky Bass Club/Trailers & Towing Moderator
    Join Date
    Jul 2004
    Location
    Winchester,KY
    Posts
    2,356

    Hydraulic Steering Part

    Anyone know if/where this can be purchased? Is there another option for this bolt/washer set up? I haven’t called Seastar yet but can’t find it by browsing the internet other than a 300 dollar kit.. This one is wore out and allowing some slip in the steering.


    http://

  2. Member
    Join Date
    Jan 2006
    Location
    Salem, wi
    Posts
    487
    #2
    Here is a link to the sea star manual
    SEASTAR OUTBOARD SLIDE FRONT MOUNT – Book 1 (3.4mb) Rev. H – 296221H

  3. SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,249
    #3
    It appears to be the slide washer is worn out it takes two #727724.

  4. Member JoePA's Avatar
    Join Date
    Jan 2005
    Location
    Tamaqua
    Posts
    5,529
    #4
    Mine is wore out as well. I was thinking of just making one as its just a square with a hole in the middle.
    Joe Galada - Tamaqua, PA
    2004 Ranger 521VX - Yamaha 250 SHO

  5. Kentucky Bass Club/Trailers & Towing Moderator
    Join Date
    Jul 2004
    Location
    Winchester,KY
    Posts
    2,356
    #5
    Thanks Fred.

    Joe I found 4 at marineparts.com. Said they were discontinued. May have to find some other alternative when these wear out.

  6. Member
    Join Date
    Jan 2006
    Location
    Salem, wi
    Posts
    487
    #6
    Greasing the slider will certainly extend the service life.

  7. Kentucky Bass Club/Trailers & Towing Moderator
    Join Date
    Jul 2004
    Location
    Winchester,KY
    Posts
    2,356
    #7
    Thank you all for the help. Slide washers arrived. Replaced the top and bottom one and greased them as recommended. Steering tightened up like it should be. Y’all have a good Thanksgiving.