1998 venom 200 Jstlece motor
Went out to crappie fishing this weekend and had some major issues, motor started better than normal no issues idled fine. Went to leave my spot and put the boat in gear and it wouldn't run over 1k rpm and stumbled and died. Fired the motor back up and put it in gear as I pushed the choke in it would pick up a and run better and starve fuel back out. Motor ran perfect last week.
Obviously a fuel issue.
I had a wiring issue which was causing only half the motor to shut down, replaced the key switch, removed the power pack cleaned all the connections. I am wondering if something was missed causing the motor to go into limp mode.
Compression is good all within 3-4lbs per hole. (roughly 110-115)