27 pitch v max prop hpdi 225.
27 pitch v max prop hpdi 225.
There’s one in the props for sale section
I don’t think so! There is an SHO propeller which is non-vented. The HPDI will not be able to run this propeller as is.Originally Posted by 1ranger487vs
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
True i need a vented prop
I’m running a non vented sho vmax t2 25 on my ranger. Same hole shot I had with my 25 trophy. Surprised me too. Ox 66 200
I’m a machinist Was going to mill some vents into it. Tried it first don’t need them.
Venting is needed on 2 strokes... Load, gear ratio, pitch hull etc all are different. The taller pitchs, loads, taller gears, bigger boats etc need venting even more
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
Not always. I’m running one and it’s fine on my rig. Thought the same till I tried it. Worst case drill some vents. Believe a Video or actual results. That’s what this forum is about. Facts
Lol. What would I know?
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
I might have one. I switched from a 27p to a 25p on my 2007 250 HPDI champion boat. The 27p is sitting in my shop floor as my backup just in case. Coach
You ran a small hub trophy on a Yamaha? I guess you blocked it all off with a weed ring?
I have never seen a Yamaha not blow out an over/thru hub prop without a ring.
I have never needed a cav ring running an OT prop on my 250 Yamaha. The HPDI is a different story.
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
This propeller is a 27M pro series. 14 1/2 inch diameter. Not the same as a T1
Marks Props 317-398-9294, 1850 East 225 South, Shelbyville, Indiana 46176 propellerman59@gmail.com http://www.marksprops.com/index.html
No it is a large hub I had on my merc
Are you just looking for a spare or you do you need a full replacment. I guess... What are you looking spend? My local shop has a couple used ones. Not sure on price or condition. I personally have 2 t1's in 27p. One is on my boat with some small dings in it. One is hanging on my wall fresh from croxton never run since its clean up. I may be interested in selling the croxton one. But it wouldnt be cheap. If you're kust looking for a spare, or less money, i could check with my shop guy and see what he has.
Reply With Quote
.jpg)
