RMP anchor light wire routing

[RichW]

Can I get some guidance on routing the wires to the RMP anchor light on a blade? Not sure if I need to provide slack or keep the wires tight. Tried both ways and it seem like I either get wires hanging out of my blade when retracted or I stretch & break them. Thanks

[BassCPT]

I gave my lines just enough slack that I could use some heavy duty gorilla tape to secure them on the front half of the pole and then I secure them to the hydraulic lines with a zip ties every foot or so until the wires are inside the boat.

[GBhoss]

I ran mine inside the PP. The instructions said to do it that way and have never had a problem.

[Phisherman]

I never read the instructions, but common sense told me to run wiring inside of the U Channel. I just used heavy duty tape and taped the wiring to the center of the U channel

[RichW]

RMP customer service sent me this pic...my mistake was using wire ties to the hydraulic lines