Results 1 to 5 of 5
  1. 10-19-2020, 10:09 AM #1
    cooper113
    cooper113 is offline
    Member
    Join Date
    Jun 2012
    Location
    columbia sc
    Posts
    89

    2004 evinrude 225HO DI stalls

    Cranks up on trailer then stalls, cranks up then stalls again but let it run for10 minutes it is fine. New plugs , fuel pressure good. Runs good after the unload off trailer but every time in the morning it does this but won’t do that on trailer at home only in water. It seems like when it Sets up over night & go to lake it does this stalling til it either warms up or fuel pressures get good on system
    Reply With Quote Reply With Quote
  2. Bassmeister
    Bassmeister is offline
    Sprint Boats Moderator Bassmeister's Avatar
    Join Date
    May 2004
    Location
    Calhoun, Ga.
    Posts
    46,462
    #2 10-19-2020, 11:38 AM
    When was the last time the plugs was changed....worn plugs will cause this....
    Reply With Quote Reply With Quote
  3. cooper113
    cooper113 is offline
    Member
    Join Date
    Jun 2012
    Location
    columbia sc
    Posts
    89
    #3 10-19-2020, 12:08 PM
    Just put them in but might be got a bad set which ones do u suggest & had pop
    Reply With Quote Reply With Quote
  4. cooper113
    cooper113 is offline
    Member
    Join Date
    Jun 2012
    Location
    columbia sc
    Posts
    89
    #4 10-19-2020, 12:08 PM
    Gap
    Reply With Quote Reply With Quote
  5. Bassmeister
    Bassmeister is offline
    Sprint Boats Moderator Bassmeister's Avatar
    Join Date
    May 2004
    Location
    Calhoun, Ga.
    Posts
    46,462
    #5 10-19-2020, 12:58 PM
    QC12PEP gapped at 0.28 and they must be indexed. If you have converted the thermostats to the Etec ones you can run The QC10WEP Irridium plugs also gapped @ 0.28 and indexed for longer life of the plugs.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »