I have a 2015 Pro XS (2 Stroke) and would like to interface it to my Lowrance Elite TI2. I have seen a few post about what you need to do it but no two were the same. Does anyone know for sure what it takes to do it? And rough cost est.?
I have a 2015 Pro XS (2 Stroke) and would like to interface it to my Lowrance Elite TI2. I have seen a few post about what you need to do it but no two were the same. Does anyone know for sure what it takes to do it? And rough cost est.?
Have a good one and thank God for it!
It will help you to receive faster, and more accurate responses if you will post your questions in the appropriate forum:
Mercury Motors (this forum)
TWO STROKE models (Less than 135 hp).
Mercury - 2.0/ 2.4/ 2.5 Liter High Performance
For discussions related to 2.0/ 2.4/ 2.5L Two Stroke motors (Carb, EFI, Optimax or Racing).
Mercury - 3 Liter & 3 Liter High Performance
For discussions related to 3L Two Stroke motors (XS, ProXS Optimax, EFI, or Racing)
Mercury - 4 Stroke / Verado
For discussions related to ALL Mercury 4 Stroke Engines.
For fastest/most-accurate assistance, please choose the correct forum.
Thanks, I should have states that my Merc is a 115 hp.
Have a good one and thank God for it!
You need a Smartcraft gateway device and functional N2k network to interface with Lowrance..
_______
Phil
'09 Hewescraft ProV
'09 150 Optimax
http://www.bbcboards.net/showthread.php?t=894952
When the above thread was written, the Lowrance HDS were the only Lowrance units capable of displaying engine data. When the Elite Ti2 was introduced, it included this same capability.
You will need either a Vessel View Link or a Level 1 (or above) Mercmonitor and their associated cables and adapters.
Additionally you will need a NMEA2000 network.
If you email Don (username EuropeanAM on here) or Rhonda Weed with the serial number of your engine, they will provide ALL that you need.
USN Retired
2020 Basscat Caracal
2020 Mercury 225 ProXS 4s