Fury prop help

[txbasscat31]

I recently bought a fury 3-blade 24p for a 2012 Mercury 200 pro xs. When I hit 60.7 mph it blows out, what would cause it to blow out at this speed?

[21XDC]

Motor is too high, Or you bought a used prop that was repaired poorly most likely.

[721Proxs]

Fury likes to run a little deep

[txbasscat31]

Prop was bought brand new. I dropped my motor down an inch and tried it but it still blows out.

[capt odie]

Over trimming??

[06 SB]

What boat is the motor attached and what is the prop to pad measurement?

[21XDC]

Prop was bought brand new. I dropped my motor down an inch and tried it but it still blows out.

Still might not be deep enough for that small diameter prop. 14 in is small for a 3 blade on a big block motor.

[txbasscat31]

Would it be better if I drop down to a 23p?

[JR19]

Do you have a transducer or anything mounted on the transom that would disrupt the water flow to the prop.

[txbasscat31]

No I don't.

[RGK456]

Still might not be deep enough for that small diameter prop. 14 in is small for a 3 blade on a big block motor.

What is the P2P starting point you would recommend for a Fury prop?

[angle iron]

What boat is this?

[krindgen]

Plugs??

[Mikes250r]

Is it blowing out on take off? If so, then definitely you need to add plugs.